The Atomic Bombings of Hiroshima and Nagasaki

The damage to man-made structures caused by the bombs was due to two distinct causes: first the blast, or pressure wave, emanating from the center of the explosion, and, second, the fires which were caused either by the heat of the explosion itself or by the collapse of buildings containing stoves, electrical fixtures, or any other equipment which might produce what is known as a secondary fire, and subsequent spread of these fires.

The blast produced by the atomic bomb has already been stated to be approximately equivalent to that of 20,000 tons of T.N.T. Given this figure, one may calculate the expected peak pressures in the air, at various distances from the center of the explosion, which occurred following detonation of the bomb. The peak pressures which were calculated before the bombs were dropped agreed very closely with those which were actually experienced in the cities during the attack as computed by Allied experts in a number of ingenious ways after the occupation of Japan.

The blast of pressure from the atomic bombs differed from that of ordinary high explosive bombs in three main ways:

1. Downward thrust. Because the explosions were well up in the air, much of the damage resulted from a downward pressure. This pressure of course most largely effected flat roofs. Some telegraph and other poles immediately below the explosion remained upright while those at greater distances from the center of damage, being more largely exposed to a horizontal thrust from the blast pressure waves, were overturned or tilted. Trees underneath the explosion remained upright but had their branches broken downward.
2. Mass distortion of buildings. An ordinary bomb can damage only a part of a large building, which may then collapse further under the action of gravity. But the blast wave from an atomic bomb is so large that it can engulf whole buildings, no matter how great their size, pushing them over as though a giant hand had given them a shove.
3. Long duration of the positive pressure pulse and consequent small effect of the negative pressure, or suction, phase. In any explosion, the positive pressure exerted by the blast lasts for a definite period of time (usually a small fraction of a second) and is then followed by a somewhat longer period of negative pressure, or suction. The negative pressure is always much weaker than the positive, but in ordinary explosions the short duration of the positive pulse results in many structures not having time to fail in that phase, while they are able to fail under the more extended, though weaker, negative pressure. But the duration of the positive pulse is approximately proportional to the 1/3 power of the size of the explosive charge. Thus, if the relation held true throughout the range in question, a 10-ton T.N.T. explosion would have a positive pulse only about 1/14th as long as that of a 20,000-ton explosion. Consequently, the atomic explosions had positive pulses so much longer then those of ordinary explosives that nearly all failures probably occurred during this phase, and very little damage could be attributed to the suction which followed.

One other interesting feature was the combination of flash ignition and comparative slow pressure wave. Some objects, such as thin, dry wooden slats, were ignited by the radiated flash heat, and then their fires were blown out some time later (depending on their distance from X) by the pressure blast which followed the flash radiation.

---